How to Replace the Front Door on the Enbio S
In this article, we’ll be going over how to replace the door or just reinstall the door of the Enbio S. The door itself was most likely removed in the event you needed to get to the door gasket for it’s maintenance, or needed to remove the front facia. Whatever the case, now it’s time to put it back in. The door replacement process is just using the guide rails to screw the door back on. Like previous articles of these processes, it sounds simple but this is once again NOT an end-user repair. We recommend a qualified technician take care of this repair. Or it can just be sent in to us, your ONLY U.S. authorized warranty, service and repair center.
We have an accompanying video here if you’re more of a visual learner.
And if you just want to talk to someone for any questions you may have, call our Free Tech Support at 704-966-1650 Option 3.
Replacing the Door
One thing to do before even trying to replace this door is to make sure that the guide rails are out. The guide rails for the door were pushed back in during some of our previous repairs so that they weren’t in the way. Now they have to be back out to attach the door to.
Attach the Door
Now it’s time to slide the door back on by sliding it onto the rails. Notice the small middle sections on both sides of the door that will each have two holes for screws. That portion is what will slide onto the guide rail and match the two holes on the rails themselves. Line up the door’s rails to the guide rails and slide it back on into its proper position.
Once the door is sitting flush to the guard rails, using a Torx T10 bit screwdriver, take the screws you took out previously and screw them all back in. There will be two on each rail holding the door up.
Lastly, once the door is attached its time to put the tray in. The tray has a certain way it fits, though. There are 3 holes on the front of the tray, and they sit and connect to the 3 prongs sticking out of the door gasket inside the door. So when the tray gets installed, make sure the 3 holes face the door and not the inside of the unit. Just slide the tray in and fit it so it sits properly against the rails and the door. Then just shut the door and everything is complete.
Process Complete
And with that, the replacement of the Enbio S Door is complete. We’ve mentioned this before but please remember that this process should be completed by a qualified technician. Or if you feel the need, send it in to us and we’ll take care of it every step of the way. And if you have any questions, you can contact us at the links below.
Attention: Enbio recommends that the described service work be performed by a certified Enbio technician. Sterilizer Autoclave Solutions is your United States authorized Enbio warranty, service and repair center.
As always if you have any questions about this process or anything else please feel free to contact us and take advantage of our “FREE TECH SUPPORT.”
We also offer FREE VIRTUAL TECH SUPPORT to “See and Talk” with a “Real Time Live Technician” for any problems you may be in need of help with.
You can also use our “FREE MAINTENANCE PROGRAM”. Take the guesswork and worrying about what unit is due for maintenance and which maintenance cycle it is time for. We will keep track of all your autoclaves and let you know when it’s time for anything.
The Enbio S Automatic Sterilizer is available for purchase here.
The Enbio S Door Assembly Kit is available here.
Any parts you require for your Enbio S can be purchased here.